EU Declaration of Conformity
EN ISO 12100-1:2010 Safety of Machinery - Basic concepts, general principles for design - Basic terminology, methodology
Suitable for use in hazardous area:
EN 12096:1997 Mechanical vibration - Declaration and verification of vibration emission values
Solvent and water based materials
This Product is designed for use with:
We: Finishing Brands UK, declare that the above product conforms with the Provisions of:
Machinery Directive 2006/42/EC
EN ISO 12100-2:2010 Safety of Machinery - Basic concepts, general principles for design - Technical principles
EN ISO 20643:2008 Mechanical vibration - Hand held and hand guided machinery - Principles for evaluation of vibration emission
HVLP and Trans-Tech products comply with the requirements of PG6 from the EPA guidelines and offer greater than 65% transfer efficiency.
EN1127-1: Explosive atmospheres - Explosion prevention - Basic concepts
Finishing Brands UK,
Ringwood Road,
Bournemouth, BH11 9LH. UK
EN ISO 11201:1995 Acoustics - Noise by machinery and equipment - Determination of emission sound pressure levels at a work station and
at other specified positions in an essentially free field over a reflecting plane with negligible environmental corrections
EN 14462:2005+A1:2009 Surface treatment equipment - Noise test code for surface treatment equipment including its ancillary handling
equipiment - Accuracy grades 2 and 3
BS EN 1953:2013 Atomising and spraying equipment for coating materials - Safety requirements
by complying with the following statutory documents and harmonised standards:
EN 13463-1: Non electrical equipment for use in potentially explosive atmospheres - Basic methods and requirements
EN ISO 28662-1 Hand-held portable power tools - Measurement of vibrations at the handle
To Next Page
Loading...
