DeVilbiss SRi PRO Lite - Advanced Spray Performance Issues; Ball End Pattern and Bounce-Back; Runs, Sags, and Finish Defects

EN
Too much air pressure.
Gun tilted at an angle.
Too much fluid flow.
Adjust gun or reduce fluid pressure.
Material too thin.
Gun too far from surface.
Check distance (normally 150-
200mm).
Excessive bounce-back.
Too much atomisation air pressure.
Runs and sags.
Thin, sandy coarse finish drying
before it flows out.
Fluid flow too low.
Increase fluid flow by changing fluid
tip size, supply pressure or turning
needle control knob counter
clockwise.
Change fluid tip for smaller size or
change air cap for different
specification air cap.
Mix properly or apply light
coats/reduce fluid flow.
Too much fluid flow.
Gun too far from surface.
Reduce air pressure.
Ball end heavy
pattern.
Reduce air pressure and check spray
pattern.
Check distance.
Mount gun at right angle to work.
SB-E-2-512 R2.0
20/24