Introduction 15
devolo dLAN 550 WiFi
* Information about the web interface can be
found in Chapter 4 Network configuration.
** Information on improving the transmission rate
can be found in Chapter 5.3 Bandwidth optimi-
zation.
***A dLAN adapter switches to standby mode
after approximately 10 minutes if no active
network device (e.g. computer) is connected to the
network interface and the WiFi is switched off. In
this mode, the dLAN adapter cannot be accessed
over the electrical wiring. As soon as the network
device (e.g. computer) connected to the network
interface is switched on again, your dLAN adapter
can also be accessed over the electrical wiring
again.
Check whether the adapter is connected to the
mains supply correctly and whether the pairing
operation has been carried out successfully. For
more information about this, refer to 3.3
Connecting the dLAN 550 WiFi.
2.4.2WiFi button
The WiFi button controls the following WiFi
functions:
WiFi On/Off:
b In the factory default settings, the WiFi set-
ting is already enabled and the WiFi encryp-
tion is set to WPA2. The WiFi key is the unique
key of the dLAN 550 WiFi. You can find this key
on the label on the rear side of the housing.
b In order to switch WiFi off, press and hold the
WiFi button longer than 3 seconds.
b In order to switch WiFi back on, tap the WiFi
button.
Connecting WiFi devices via WPS
b If the device is still on factory defaults, tap the
WiFi button in order to activate WPS.
b If the WiFi connection was switched off and
you would like to activate WPS, press the
To Next Page
Loading...
Need help?
General
