Introduction 14
devolo dLAN WiFi Outdoor
2.4.1PLC button
This button controls the following functions:
Encrypting the dLAN network
b To encrypt your dLAN network individually,
press each PLC button on the connected
devices for approx. 1 second – within 2 minu-
tes.
b To remove a dLAN device from your network,
press the PLC button on the corresponding
device for at least 10 seconds.
For more information, refer to Chapter 3.5 Re-
moving the adapter from the network.
Reading the PLC indicator light
The integrated indicator light (LEDs) shows the
dLAN status for the dLAN WiFi Outdoor by illumi-
nating and/or flashing:
Check whether the adapter is connected to the
mains supply correctly and whether the encryp-
tion process has been carried out successfully.
For more information about this, refer to 3.3
Connecting the dLAN WiFi Outdoor.
PLC LED Flashing behaviour Meaning LED status display
(web interface*)
1 Red LED Lights up steady Adapter is in the start-up
process
Cannot be disabled
2 Red LED Flashes at intervals of 0.5
sec. (on/off)
No dLAN connection
exists
Cannot be disabled
3 Red LED Flashes at intervals of 2
sec. (on/off)
Data transmission rate
not in optimum range *
Can be disabled
dLAN WiFi Outdoor.book Seite 14 Mittwoch, 30. Oktober 2019 10:47 10
To Next Page
Loading...
