Introduction 16
devolo dLAN WiFi Outdoor
WiFi On/Off:
b In the factory default settings, the WiFi set-
ting is already enabled and the WiFi encryp-
tion is set to WPA2. The WiFi key is the unique
key of the dLAN WiFi Outdoor. You can find
this key on the inside label. Open the lid of the
dLAN WiFi Outdoor in order to have access
to the label and the two buttons.
b In order to switch WiFi off, press and hold the
WiFi button longer than 3 seconds.
b In order to switch WiFi back on, tap the WiFi
button.
Connecting WiFi devices via WPS
b If the device is still on factory defaults, tap the
WiFi button in order to activate WPS.
b If the WiFi connection was switched off and
you would like to activate WPS, press the
WiFi button twice; once to switch WiFi on,
and again to activate WPS.
WPS, developed by the WiFi Alliance, is one of
the encryption standards in a WiFi network. The
objective of WPS is to make it easier to add de-
vices to an existing network. For more detailed
information, refer to Chapter 4.4.7 WiFi Pro-
tected Setup (WPS).
Reading the WiFi indicator light
The integrated indicator light (LED) shows the WiFi
status for the dLAN WiFi Outdoor by illuminating
and/or flashing:
WiFi LED Flashing behaviour Meaning LED status display
(web interface*)
1White
LED
Flashes at intervals of
0,1 sec. on/5 sec. off
The dLAN adapter is in WPS mode
to integrate WiFi-enabled devices
via WPS.
Cannot be disabled
2White
LED
Lights up steady WiFi is switched on and active. Can be disabled
dLAN WiFi Outdoor.book Seite 16 Mittwoch, 30. Oktober 2019 10:47 10
To Next Page
Loading...
