DeWalt 208-DS - Page 3

3
DANGER: Failure to read the Owner’s Manual prior to operating or servicing your DEWALT machine could result in injury to you or to
other personnel; damage to the machine or to other property could occur as well. You must have training in the operation
of this machine before using it. If you or your operator(s) cannot read English, have this manual explained fully before
attempting to operate this machine.
DANGER: A. Sanding/nishing wood oors can create an explosive or combustible environment. Do not operate this machine around
solvents, thinners, alcohol, fuels, oor nishes, wood dust or any other ammable materials. Cigarette lighters, pilot lights,
electrical sparks and all other sources of ignition should be extinguished or avoided. Keep work area well ventilated.
B. Dust generated from sanding wood oors can spontaneously ignite or explode. Promptly dispose of any sanding dust in
a metal container clear of any combustibles. Do not dispose in a re.
DANGER: A. Electrocution could occur if the machine is being serviced while the machine is connected to a power source.
Disconnect the power supply before servicing.
B. Electrocution or re could occur if the machine is being operated with a damaged power cord. Keep the power cord
clear of the pad. Always lift the cord over the machine. Do not move the machine by the power cord.
C. Shock hazard. Do not use the machine if it has been rained on or sprayed with water.
DANGER: To avoid injury keep hands, feet, and loose clothing away from all moving parts on the machine. Disconnect the power cord
before replacing the pad, changing the abrasive, or when servicing. Do not operate the machine unless all guards are in
place. Never leave the machine unattended while connected to a power source.
DANGER: Bodily injury could occur if power is applied to the equipment with the power switch already in the "ON" position. Always
check to assure the power switch is in the "OFF" position before connecting power supply.
WARNING: Injury can occur if protective clothing or equipment is not used while sanding. Always wear safety goggles, protective
clothing, and dust mask while sanding.
WARNING: This sander is not to be used on pressure treated wood. Some pressure treated woods contain arsenic and sanding
pressure treated wood produces hazardous dust. Inhaling hazardous dust from pressure treated wood can cause serious
injury or death. Sanding pressure treated wood decks or uneven surfaces can damage the sander which is not covered
under warranty or damage waiver.
WARNING: Any alterations or modications of this machine could result in damage to the machine or injury to the operator or other
bystanders. Alterations or modications not authorized by the manufacturer voids any and all warranties and liabilities.
WARNING: Risk of explosion. Floor sanding can result in an explosive mixture of ne dust and air. Use oor sanding machine only in a
well-ventilated area free from any ame or match.
A SPECIAL WARNING ABOUT BAG FIRES
Dust generated from sanding raw or previously nished wood oors CAN SPONTANEOUSLY IGNITE OR EXPLODE!
The sanding machine’s DUST CONTAINMENT BAG MUST BE EMPTIED FREQUENTLY and before any work stoppage.
NEVER STORE SANDING DUST IN OR AROUND STRUCTURES OR OTHER COMBUSTIBLE MATERIALS.
Promptly dispose of any sanding dust outside in accordance with local regulations. Do not dispose in a re.
ENGLISH
CAUTION: Serious damage to the oor can occur if the machine is left running in one spot while the sanding drum is in contact
with the oor. To avoid damage to the oor, feather cut in at a normal sanding rate. Do not dwell while lowering or
raising the contact wheel. Always sand at a constant rate.