EasyManuals Logo

DeWalt DCD780 Instruction Manual

DeWalt DCD780
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
English
4
WARNING: Always wear proper personal hearing
protection that conforms to ANSI S12.6 (S3.19) during
use. Under some conditions and duration of use, noise from this
product may contribute to hearing loss.
CAUTION: When not in use, place tool on its side on a
stable surface where it will not cause a tripping or falling
hazard. Some tools with large battery packs will stand upright on
the battery pack but may be easily knocked over.
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ................... volts A ...................... amperes
Hz ................. hertz W .....................watts
min ............... minutes
or AC ..........alternating
or DC ... direct current current
................. Class I Construction or AC/DC ...alternating
.....................
(grounded) ........................or direct
................. Class II Construction current
(double insulated)
n
o ....................no load
…/min .......... per minute speed
BPM ............. beats per minute
n ......................rated
IPM ...............impacts per minute
........................speed
RPM ............. revolutions per
.....................earthing
minute terminal
sfpm ............. surface feet
..................... safety alert
..................... per minute symbol
SPM ............. strokes per minute
Important Safety Instructions for All
Battery Packs
When ordering replacement battery packs, be sure to include the
catalog number and voltage. Consult the chart at the end of this
manual for compatibility of chargers and battery packs.
The battery pack is not fully charged out of the carton. Before
using the battery pack and charger, read the safety instructions
below and then follow charging procedures outlined.
READ ALL INSTRUCTIONS
Do not charge or use the battery pack in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust. Inserting or removing the battery pack
from the charger may ignite the dust or fumes.
NEVER force the battery pack into the charger. DO NOT
modify the battery pack in any way to fit into a non-
compatible charger as battery pack may rupture causing
serious personal injury. Consult the chart at the end of this
manual for compatibility of batteries and chargers.
Charge the battery packs only in designated D
EWALT chargers.
DO NOT splash or immerse in water or other liquids.
Do not store or use the tool and battery pack in locations
where the temperature may reach or exceed 105°F (40°C)
(such as outside sheds or metal buildings in summer). For
best life store battery packs in a cool, dry location.
NOTE: Do not store the battery packs in a tool with the
trigger switch locked on. Never tape the trigger switch in
the ON position.
WARNING: Fire hazard. Never attempt to open the battery pack
for any reason. If the battery pack case is cracked or damaged,
do not insert into the charger. Do not crush, drop or damage
the battery pack. Do not use a battery pack or charger that has
received a sharp blow, been dropped, run over or damaged in
any way (e.g., pierced with a nail, hit with a hammer, stepped on).
Damaged battery packs should be returned to the service center
for recycling.
WARNING: Fire hazard. Do not store or carry the battery
pack so that metal objects can contact exposed battery
terminals. For example, do not place the battery pack in aprons,
pockets, tool boxes, product kit boxes, drawers, etc., with loose
nails, screws, keys, etc. Transporting batteries can possibly
cause fires if the battery terminals inadvertently come in

Other manuals for DeWalt DCD780

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DeWalt DCD780 and is the answer not in the manual?

DeWalt DCD780 Specifications

General IconGeneral
Chuck capacity (max)13 mm
Chuck capacity (min)1.5 mm
Idle speed (1st gear)600 RPM
Idle speed (2nd gear)2000 RPM
Drilling diameter in wood (max)38 mm
Maximum torque (hard applications)60 N⋅m
Maximum torque (soft applications)23 N⋅m
Product colorBlack, Yellow
Product designPistol grip drill
Power sourceBattery
Battery voltage18 V
Battery capacity4 Ah
Weight and Dimensions IconWeight and Dimensions
Depth80 mm
Width190 mm
Height236 mm
Weight1840 g

Related product manuals