English
3
Extension, Work Support: DW7080
Used to support long overhanging workpieces, the work support is user
assembled. Your saw table is designed to accept two work supports; one on
each side. (Page 3)
Adjustable Length Stop: DW7051
Requires the use of one work support. It is used to make repetitive cuts of the
same length from 0 to 42".
Clamp: DW7082
Used for firmly clamping workpiece to the saw fence for precision cutting.
Crown Molding Fence: DW7084
Used for precision cutting of crown molding.
Miter Saw Work Station: DW730
Workstation provides fast, easy set up for material support and accurate
measuring system.
SAW BLADES: ALWAYS USE 10" SAW BLADES WITH 5/8" (16mm) ARBOR
HOLES. SPEED RATING MUST BE AT LEAST 5500 RPM.
DEWALT NO. OF BLADE APPLICATION TYPE OF CUT
BLADE TEETH DESC.
RANGE
Series 20 40 Thin Kerf Gen. Purpose Smooth,
Construction Yellow Rim (Trim, Decking, Splinter Free
Coating Framing)
Series 20 60 Thin Kerf Fine Trim Very Smooth,
Construction Yellow Rim Molding Splinter Free
Coating
Series 40 40 Laser Cut Body Gen. Purpose Smooth,
Woodworking Large Carbide (Trim, Decking, Splinter Free
Teeth Framing)
Series 40 60 Laser Cut Body Fine Trim, Very Smooth,
Woodworking Large Carbide Molding Splinter Free
Teeth
Series 40 80 Laser Cut Body Fine Trim Ultra Smooth,
Woodworking Large Carbide Molding Splinter Free
Teeth Decorative
Hardwood
& Plywood
Series 40 80 Laser Cut Body Melamines, Ultra Smooth
Woodworking Large Carbide Veneers, Chip/Splinter
Teeth, Special Laminates Free
Tooth Geometry
Series 40 60 Laser Cut Body Plastics, Corian
®
Very Smooth
Woodworking Special Tooth and other solid Chip Free
Geometry surface materials
Series 40 80 Laser Cut Body Non-ferrous metals Very Smooth
Woodworking Special Tooth (aluminum, copper, Burr Free
Geometry brass, etc.)
To Next Page
Loading...
Need help?
General
