DeWalt DWFP55120 - Troubleshooting Electrical and Pressure Problems; Fuse, Breaker, and Voltage Issues; Tank Pressure and Pressure Switch Interaction

17
English
CODE POSSIBLE CAUSE POSSIBLE SOLUTION
18
Fuse blown, circuit breaker tripped 1. Check fuse box for blown fuse and replace as necessary. Reset circuit
breaker. Do not use a fuse or circuit breaker with higher rating than that
specified for your particular branch circuit.
2. Check for proper fuse. Use only a time delay fuse.
3. Check for low voltage conditions and/or proper extension cord.
4. Disconnect the other electrical appliances from circuit or operate the
compressor on its own branch circuit.
19
Tank pressure exceeds pressure switch cut-
in pressure
Motor will start automatically when tank pressure drops below cut-in
pressure of pressure switch.