DEWESOFT DEWE-43A - Start up of the Device

DEWE-43A
TECHNICAL REFERENCE MANUAL






Image 29: DewesoftX® settings

In the Devices section, you can see the connected DEWE-43A device. When you select one of them, the
properties pane at the right will show the related data e.g. Serial number, Firmware version, etc.


Image 30: DewesoftX® settings: Device

6.2.1. Start up of the device
When DewesoftX® has started up, you will be in the Measure mode and see the Setup files list or you
can create a New setup (1). Click on Ch. setup (on the right of Setup files) to switch to the Channel setup
mode (2). In the channel setup you can see a preview of the connected devices on the upper left side.


Image 31: Setup files


DEWE-43A V20-2 25/38 