8514-272-001 REV C page 13
PROGRAMMING THE DRYER CONTROL
The dryer control can be programmed to prompt the user for alternate vend prices, change dryer cycle times,
temperatures and many other options. This can be accomplished in two ways:
1. Manual programming utilizing the “Start”, “High”, “Medium” and “Low” buttons for the bottom dryer.
2. USB download of a customizable User File. For instructions on using the USB download feature, please
contact your local Dexter distributor or visit DexterLive.com.
MANUAL PROGRAMMING:
The dryer must be in idle mode for the manual programming menus to be accessed. Idle mode is when the dryer
is not actively running a drying cycle and the vend price is displayed on the screen (for both upper and lower
dryers).
To enter the manual programming mode, the control tray on the dryer must be unlocked and pulled out to reveal
the programming button. The programming button is then pressed for 1 second. The control should display
“DRYER PROGRAMMING”.
See the figure below for the location of the programming button on the control tray.
To Next Page
Loading...
