48
Part # 8533-090-001 7/21
Usage Menu:
The Usage menu allows for the user to track data about machine usage. See below for detailed information
on each sub menu option.
1. “Coin Audit”: The coin audit eld shows the accumulation of coin pulses that were sent to the
control over each of the left and right coin inputs. Note that this is a count of coin pulses,
not an accumulated report of vend value.
a. The user can also return the coin audit amounts to the factory default setting (zero). To
reset all coin audit values, press “Enter” when the “DEFAULT” prompt is shown.
Press “Enter” again when the “RESET” prompt is shown to conrm the action.
2. “Motor Hours”: The motor hours eld shows the accumulated hours of operation for both the
upper and lower motors independently. In many cases, it will match the cycle hours of the
machine. However, separate elds are provided in the event that a motor is replaced on
a machine. The user can set the motor hours to a designated number. For example, if it is
necessary to replace the control on a machine, the new control could be programmed to
show the motor hours that were recorded by the previously installed control. The
individual digits of the hours count can be set by using the “Up” or “Down” buttons
to change the number that is ashing. Once the desired digit of the hours is chosen, press
the “Enter” button to move to the next digit. Once the complete hours are chosen,
the “Enter” button must be held down for 3 seconds to conrm the action.
a. The user can also return the motor hours to the factory default setting (zero). To reset
the motor hours, press “Enter” when the “DEFAULT” prompt is shown. Press “En
ter” again when the “RESET” prompt is shown to conrm the action.
3. “Cycle Hours”: The cycle hours eld shows the accumulated hours of operation for both the
upper and lower dryer dryers independently. In many cases, it will match the motor hours
of the machine. However, separate elds are provided in the event that a motor is replaced
on a machine. See the Motor Hours description for more information.
The gure below shows the sub menu options for Usage:
To Next Page
Loading...
Need help?
General
