8514-238-001 REV PR page 15
3.1.9
To select a different cycle to program, press the “STOP” button
again.
If desired, repeat steps 3.1.3 through 3.1.8 to program another
cycle.
3.1.10
To end programming, turn the key to “RUN” position.
It is recommended when changes are made to one or more of the
preset programs that the cycle number and the changes be
documented for later reference. Blank cycle tables have been
provided at the end of section 3.2.
NOTE: The Wash Cycle programming mode will automatically exit and
return to the Idle mode if no buttons are pressed for one minute.
3.2 DEFAULT WASHER CYCLE PROGRAMS
The factory default cycles pre-programmed into the washer are listed with
each bath and setting option in this section.
Sheets & Pillowcases (Health Care)
Towels / Pads / Diapers (Health Care)
White Towels (Hotel / Motel)
Guest Laundry (Hotel / Motel or Health Care)
Rags & Mops (Hotel / Motel)
Colored Cotton Linen (Food & Beverage)
To Next Page
Loading...
Need help?
General
