Dexter Laundry T-400 On-Premise User Manual

8514-238-001 REV PR page 21
11
The drive size setting has changed.
Turn off the power to the washer. Check to ensure all the harnesses are properly connected
to the controller. Check to ensure the drive horsepower is proper for this size of washer.
Turn on power to the washer. (See Note) If problem reappears, contact your Dexter
representative.
12
Washer controller internal error
Turn off the power to the washer. Wait one minute. Turn on the power to the washer.
(See Note) If problem reappears, contact your Dexter representative.
13
The control cannot communicate with the drive
Turn the power off to the washer. Check the data cable between the controller and the
drive. If no problem is observed, turn on power to the washer and test. (See Note) If
problem reappears, contact your Dexter representative.
14
Over-current on the drive or motor.
Turn the power off to the washer. Check the washer motor to ensure it turns freely. Check
the wiring connections to the drive and motor. If no problem is observed, turn on power to
the washer and test. (See Note) If problem reappears, contact your Dexter representative.
15
Over-voltage on the drive or motor.
Turn the power off to the washer. Check the washer motor to ensure it turns freely. Check
the wiring connections to the drive, braking resistors and motor. Measure incoming line
voltage. If no problem is observed, turn on power to the washer and test. (See Note) If
problem reappears, contact your Dexter representative.
16
Overheating of the drive
Turn the power off to the washer. Allow the drive to cool. Check the cooling fins of the
drive to ensure proper airflow. Check the wiring to the drive including the fan wiring. If no
problem is observed, turn on power to the washer and test. (See Note) If problem
reappears, contact your Dexter representative.
17
Overload of the drive or motor
Turn the power off to the washer. Check the washer motor to ensure it turns freely. Check
the wiring connections to the drive and motor. If no problem is observed, turn on power to
the washer and test. (See Note) If problem reappears, contact your Dexter representative.
18
Ground Fault to the drive
Turn the power off to the washer. Check the wiring connections to the drive and motor.
Check the ground wiring of the drive, motor and incoming connection to ensure a proper
ground is present. If no problem is found, contact your Dexter representative.
19
Low Voltage to the drive
Turn the power off to the washer. Check the wiring connections to the drive and motor. If
no problem is observed, turn on power to the washer and test. (See Note) Measure the
incoming line voltage. If problem reappears, contact your Dexter representative.
20
Internal drive error
Turn the power off to the washer. Wait one minute. Turn the power on to the washer.
(See Note) If problem reappears, contact your Dexter representative.
21
Data error on communications between the
controller and drive
Turn the power off to the washer. Check the data cable between the controller and the
drive. If no problem is observed, turn on power to the washer and test. (See Note) If
problem reappears, contact your Dexter representative.
Note: Whenever power is turned off to the washer, it must remain off for one minute. The washer will not operate properly if this is not done.

Dexter Laundry T-400 On-Premise Specifications

General

Brand	Dexter Laundry
Model	T-400 On-Premise
Category	Washer
Language	English