DFRobot OverLord 3D - Belt Tensioning; Build Plate Gluing (OverLord Pro)

OverLord 3D Printer User Manual
46
3.4 Fastening the belt
Why:
Frequently printing operation may cause mechanical fatigue in belt, and the belt becomes longer
and longer. This may affect the quality of print too. If the print quality goes down however there is
no problem in the extrusion of material, maybe you would like to check whether the belt is
fastened or not.
How:
1. Find the belt fastener 5cm below the slider on rod.
2. Screw it clockwise to fasten the belt until it reaches the state shown below.
3.5 How to paint the glue before printing （Only for OverLord Pro）
Why: