Why is my DGFLOW Control Panel pump's performance low?
If the DGFLOW Control Panel's pump performance is below the plate specifications, it could be due to air inside the suction manifold or a blocked/damaged pump. Bleed the suction system and inspect the pump to eliminate any blockages or damage.
How to fix a tripped circuit breaker on DGFLOW Control Panel?
If the current circuit breaker has tripped, it may be because the residual current circuit breaker is inadequate for the inverter supply. Replace the residual current circuit breaker with a model suitable for pulsating components and direct current (class A or B).
Why won't my DGFLOW Control Panel's VARIABLE SPEED pump start?
If the VARIABLE SPEED pump fails to start, several issues could be the cause. These include the pump being out of service, lack of water at suction, excessive overcurrent absorption, short circuit, no communication between control board and power board, no pressure signal, lack of phase during operation, wrong power wiring, no level signal, or the pump working dry. Here are a few things to check: * Put the pump back into service. * Check for water at suction, prime the pump, and clean the suction. * Check and correct the motor rotation and set the parameter PD to a lower value. * Check the correct current setting and voltage at pump terminals. * Ensure the motor is turning freely and there are no short circuits. * Check the integrity of the connection cable and connections. * ...
Details on connecting input signals for sensors and control.
Details on connecting output signals for relays and indicators.
Sets up basic operational parameters like working pressure and pump current.
Configures advanced parameters for optimizing plant engineering situations.
Sets up signal inputs and outputs on the control board.
Verify MOTOR FREQ parameter matches the motor plate frequency.
Verify MAX FREQ parameter matches motor plate frequency.
Set the shutdown frequency for operation without a flow sensor.
Enter the full-scale value for connected pressure sensors.
Configure the flow sensor parameter.
Overview of DGBOX control panels for single and multi-pump units.
Access and modify working parameters, including base, advanced, hardware setups, and maintenance.
Perform manual functional tests on variable-speed and fixed-speed pumps.
Normal operating mode, controlling parameters and displaying alarms.
Manually stop the system or single pumps for maintenance or configuration.
Perform DGBOX maintenance or software update operations via USB.
General| Brand | DGFLOW |
|---|---|
| Model | DGB MV 30 |
| Category | Control Panel |
| Language | English |
To Next Page
