PPC3™ OPERATION AND MAINTENANCE MANUAL
© 2002-2007 DH Instruments, a Fluke Company Page 68
Table 10. Reset – Cal
RESET RESULT SEE SECTION
All Q-RPT user calibration
coefficients
PA to zero, PM to 1. 5.2.1.1, 5.2.7
Axxx Q-RPT absolute and
negative gauge mode
ON. 5.2.5
Utility Sensor calibration
coefficients
PA to zero, PM to 1. 5.4
On-board barometer
calibration coefficients
PA to zero, PM to 1. 5.3
Calibration date Set all dates to 19800101. 5.2.7, 5.4, 5.3
AutoZ values All P
offset
values to zero for absolute mode and
101325 Pa for gauge and negative gauge modes.
3.5.1
AutoZ function ON, all Q-RPTs, all measurement modes. 3.5.1
3.5.4.5 <5ALL>
PURPOSE
The reset - all function clears and deletes large amounts of user defined
information including critical calibration data.
Combines all resets in one global reset command that clears the entire user
section of non-volatile memory returning PPC3 to the “as delivered” condition
except the ID function (see Section
3.5.5.4) and the security level password
(see Section
3.5.5.5). The Reset – All resets are itemized in Table 11.
Table 11. Reset – All
RESET RESULT SEE SECTION
Reset – Sets All the resets of Reset - Sets 3.5.4.1
Reset – Units All the resets of Reset - Units 3.5.4.2
Reset – Atest All the resets of Reset - ATest 3.5.4.3
Reset – Cal All the resets of Reset - Cal 3.5.4.4
Remote Interfaces COM1, COM2 and IEEE-R88 interfaces to
default settings.
3.5.2
Remote Communications Remote command format to Classic. 3.5.2.3
Level (Security) Low. 3.5.5.5
3.5.5 <5PREFS>
PURPOSE
To access a menu of PPC3 operational preferences and functions.
OPERATION
To access the PREFS menu press [SPECIAL],
<5prefs>. The display is:
1ScrSvr 2sound 3time
4ID 5level
The PREFS menu includes:
<1ScrSvr> View and change the screen saver activation time (see Section
3.5.5.1).
<2sound> View and change the keypress sounds (see Section
3.5.5.2).
To Next Page
Loading...