Dialogic SS7G2X - SGIRC - Signaling Gateway Incoming Route Change; SGIRE - Signaling Gateway Incoming Route End

110
Chapter 6 Command Definitions
6.12.6 SGIRC – Signaling Gateway Incoming Route Change
Synopsis
This command changes the configuration of a Signaling Gateway incoming route.
For RKTAB/DEST, a value of “null” is supported. “null” indicates a wildcard value and means any value. “null”
is the default value for an RKTAB/DEST entry.
Note: The value “null” cannot be used for these parameters elsewhere in the system unless explicitly
specified in the command.
Syntax
SGOPC:IR=,[RKTAB=,][DEST=,][LABEL=];
Prerequisites
• The incoming route already exists.
• If specified, the destination index exists.
• The NC/DOMAIN combination has already been initiated.
• Either an RKTAB or DEST must exist.
Attributes
CONFIG
Examples
SGIRC:IR=1,DEST=5;
6.12.7 SGIRE – Signaling Gateway Incoming Route End
Synopsis
This command ends the configuration of a Signaling Gateway incoming route.
Syntax
SGIRE:IR=;
Prerequisites
• The incoming route already exists.
Attributes
CONFIG
Examples
SGIRE:IR=1;