Dialogic SS7G2X - CNRDC - Configuration Remote Data Centre Change; CNRDE - Configuration Remote Data Centre End

55
Dialogic
®
SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.5.13 CNRDC – Configuration Remote Data Centre Change
Synopsis
This command is used to change the configuration of a Remote Data Centre (RDC).
Syntax
CNRDC:RDC=,{[IPADDR=,][USER=,][PASSWORD=,][LABEL=,]};
Prerequisites
• The RDC is already initiated and blocked.
• If specified, the IP address is not already in use.
• Remote data operation must be allowed by the system.
Attributes
CONFIG
Examples
CNRDC:RDC=1,IPADDR=194.192.184.77,USER=JOHN,PASSWORD=BAZZA23;
6.5.14 CNRDE – Configuration Remote Data Centre End
Synopsis
This command is used to end a Remote Data Centre (RDC).
Syntax
CNRDE:RDC=;
Prerequisites
• The RDC is already initiated.
• The RDC is blocked.
• The RDC is not attached to a continuous record or periodic report.
Attributes
CONFIG
Examples
CNRDE:RDC=1;