Dialogic SS7G2X - SNALP - SIGTRAN Application Server List Print; SNAPI - SIGTRAN Application Server Initiate

116
Chapter 6 Command Definitions
6.13.3 SNALP – SIGTRAN Application Server List Print
Synopsis
This command reports the relationship between a SIGTRAN Application Server (AS) and SIGTRAN links.
Syntax
SNALP;
SNALP:AS=;
SNALP:SNLINK=;
Prerequisites
• The server/hunt sequence combination has already be initiated.
Attributes
None
Examples
SNALP;
Output Format
Application Server List Configuration
AS AS LABEL SEQ SNLINK SNLINK LABEL
1 AS1 1 1 ASP1
1 AS1 2 2 ASP2
2 AS2 1 3 ASP3
EXECUTED
6.13.4 SNAPI – SIGTRAN Application Server Initiate
Synopsis
This command initiates an adjacent Application Server (AS). An AS is a logical entity representing an SS7
end point that can process either circuit-related or non circuit-related signaling. The end point is represented
by a routing context which uniquely identifies a routing key combination of SIO/DPC/OPC and CIC range.
See Section 7.2, “Signaling Configuration” on page 136 for a more detailed description of SIGTRAN signaling
configuration.
Syntax
SNAPI:AS=,DPC=,RC=,NC=,[PCMD=,][NASP=,][LABEL=,];
Prerequisites
• The AS has not already been initiated.
• No other AS can use the routing context.
• No more than 32 ASs can be configured with the same DPC/NC combination.
• All ASs within the same DPC/NC combination must have the same PCMD value.
Attributes
CONFIG
Examples
SNAPI:AS=1,DPC=555,RC=1,NC=1;