Dialogic SS7G2X - CNTDS - Configuration Time and Date Set; CNTDP - Configuration Time and Date Print

60
Chapter 6 Command Definitions
6.5.19 CNTDS – Configuration Time and Date Set
Synopsis
This command is used to specify the date (DATE) and time (TIME) as used by the system. System time is
used by the Signaling Gateway to indicate the time an alarm occurred or cleared and to provide timestamps
for such things as measurements and data records.
See the CNTDP command to verify the time and date settings.
Syntax
CNTDS:{[DATE=,][TIME=,]};
Prerequisites
• The date cannot be changed if periodic reports or continuous records are configured.
Attributes
CONFIG
Examples
CNTDS:DATE=2001-10-03,TIME=18:32:21;
6.5.20 CNTDP – Configuration Time And Date Print
Synopsis
This command is used to print the system date and time.
Syntax
CNTDP;
Prerequisites
None
Attributes
None
Examples
CNTDP;
Output Format
2001-10-03 09:04:02
EXECUTED