Dialogic SS7G2X - MMLOS - MML Log off Set; MMPTC - MML Port Change

82
Chapter 6 Command Definitions
6.8.3 MMLOS – MML Log Off Set
Synopsis
This command sets the current log-on time-out (TLO) and timeout warning (TLOW) parameters. If TLOW is
set to zero, the automatic time-out is disabled. If port (PORT) is omitted, the command applies to all ports.
Syntax
MMLOS:{[TLO=,][TLOW=,]}[PORT=,];
Prerequisites
None
Attributes
CONFIG
Examples
MMLOS:TLO=35;
MMLOS:TLOW=19;
6.8.4 MMPTC – MML Port Change
Synopsis
This command sets the data input/output parameters for serial and telnet data ports.
Note: Only serial port 2 (COM2) is accessible by the user.
Syntax
MMPTC:PORT=,{[BAUD=,][DBITS=,][PARITY=,][SBITS=,][LINES=,][PTMODE=,]};
Prerequisites
• No user must be logged on to the port affected.
• For the telnet ports, only the LINES parameter can be changed.
Attributes
CONFIG
Examples
MMPTC:PORT=2,BAUD=300;
MMPTC:PORT=2,SBITS=2;