PROLYTE ANALYZER
18
Repair
3.a Repair Overview
Always consult the TROUBLESHOOTING SECTION first to determine the problem before
attempting to repair the analyzer.
Always remove the solutions pack and the electrode housing from the
analyzer before beginning any repair work. Refer to the
proLYTE
Operator’s Manual
for detailed instructions.
Follow the assembly and removal instructions in the order outlined in this section unless otherwise
noted. Always unplug the power cord from the analyzer before beginning any repair work.
Note that only complete mechanical and electronic assemblies can be replaced. Refer to the Replacement
List in the PRODUCT DESCRIPTION SECTION which lists replaceable assemblies as well as
consumable items. Consult the list to determine the appropriate replacement item and part number.
3.b Recommended Tools
The following is a list of the tools required to perform repairs on the proLYTE analyzer.
Please refer to this list to determine the appropriate tool and size needed.
0.050 Hex Driver
5/16” Hex Driver
3/16” Hex Driver
Phillips Screw Driver, One Small
Phillips Screw Driver, One Large
Allen Wrench, 1/16 inch
Scissors
Hex Nut Driver, 11/32 inch, electrode jack installation and removal tool
Volt Meter
Chapter
3
To Next Page
Loading...