Diamondview DV65UM - Adv. Setup Menu

30
Adv. Setup Menu
Smart light control
Enable dynamic contrast (DCR) or ambient light sensor
Options: Off, DCR, Light Sensor; Default: Off
IRFM
Creates slight frame motion to help avoid image retention.
Options: On
Default: Off
Wake Up from Sleep
Select a source to wake up the display from sleep mode
Options: VGA Only, Digital, RS232, Ethernet, Never Sleep
Default: VGA Only
DP1 Ver.
Select the DisplayPort version of the DP1 input
Options: 1.1, 1.2
Default: 1.2
Note: DisplayPort 1.2 is the more modern standard and supports 3840x2160 @ 60
Hz resolution. However, sometimes DisplayPort 1.1 is needed for compatibility
with older graphics cards.
DP2 Ver.
Select the DisplayPort version of the DP2 input
Options: 1.1, 1.2
Default: 1.2
Note: DisplayPort 1.2 is the more modern standard and supports 3840x2160 @ 60
Hz resolution. However, sometimes DisplayPort 1.1 is needed for compatibility
with older graphics cards.
EDID Setup
Select EDID (Extended Display Identification Data) of the HDMI and DisplayPort inputs
Options: HDMI 1, HDMI2: 1080p, 4K2K 30Hz;
DP1, DP2, HDMI 3, HDMI 4 and OPS:
1080p, 4K2K 30Hz, 4K2K 60Hz.
Default: HDMI 1, HDMI2: 4K2K 30Hz; Other inputs: 4K2K 60Hz.
Note: Use the 1080p setting
for the broadest support of lower resolution sources. Use
the 4K2K setting to support high resolution sources such as 3840x2160.
Factory Reset
Restores all settings to their default.
Options: No, Yes Default: No