500 Series
29
T/FT
X
T/FT
X
C
X
X
X
15. Enter an extra date (best before date, etc...). If you wish to
enter an expiry time, press T/FT and enter it directly.
Press X to proceed to define the PLU tare.
16. Tare. In this field the tare associated to the product is defined.
There are two ways of entering this value:
1. Using the number keys.
2. By placing the weight to be tared on the platform
and pressing T/FT.
Press X to proceed to define the text lines for the PLU.
17. Text lines. There are a total of 10 text lines with a maximum of
24 characters per line available for each article. These lines may
contain text, INGREDIENTS or a combination of text and
ingredients.
If the article is to be supplied with text lines, press C until Yes
can be selected.
To enter an ingredient in one of the text lines in any position,
press PRINT and enter the four-character code of the
ingredient. Press
∗
∗∗
∗
after entering each ingredient.
To change lines press X.
18. General text*. Each article may have up to 1024* characters of
text. Use F4 to move 1 characterforwards in groups and F3 to
move 1 character backwards. Pressing on + during two
seconds to go to the last character of the text. Pressing – during
two seconds to go to the first character of the text..
Press X to proceed to define the PLU EAN.
19. EAN 13. The EAN code for the article is defined in this field.
Use the number keys to enter the EAN code for the article or
use a scanner. Press X to proceed to define the PLU class.
20. CLASS:
This is to define whether the article has traceability.
1. CLASS = 0: No traceability. Press
∗
∗∗
∗
to end PLU programming.
2.
CLASS ≠
≠≠
≠ 0: Traceability. The class to which the PLU belongs is
assigned here. There are 10 different classes.
21. IDN
If a class was assigned to the PLU in the foregoing point, then
the Identification Product Number (IDN) to which the PLU
belongs must be assigned in this field using the number keys.
The number may range from 1 to 20*.
Press X to proceed to define the recipe to be associated to the
PLU.
* According to model.
• Models: W-010, W-015 & M-510,M-515 Maximum 10
• Models: W-020, W-025 & M-520,M-525 Maximum 20
* According to model.
• Models: W-010, W-015 & M-510,M-515 Maximum 1
• Models: W-020, W-025 & M-520,M-525 Maximum 2
If the PLU has traceability,.
* According to model.
• Models: W-010, W-015 & M-510,M-515 Maximum 1
To Next Page
Loading...
