500 Range
5
2. OPERATION
2.1. SWITCHING ON
Check that the weighing scales are correctly installed and then
turn on the switch on the bottom of the scales.
While the scales are checked for any possible errors, the
display shows a countdown from 9 to 0, and information on the
model, programme version and maximum range of the scales is
shown.
When the countdown is complete, and no errors have been
detected, articles and ingredients are checked, and the display
shows some dashes to indicate the scale range.
When the scales are switched on, there should not be
anything on the plate, because when the object is removed,
the scales will consider that weight as the net weight.
If the message, CONNECT THE COMPUTER appears after
countdown, press any key to enter the scales' normal
operation mode.
If the scales are programmed as SLAVE and the
corresponding MASTER is not working the message LOADING
DATA will appear, and the scales will remain in this status, press
any key for the scales to enter normal operation mode.
To Next Page
Loading...
