Rev. 1.2 (12.2021) MINI-CUBE | SERVICE MANUAL 7
LIMITATIONS AND WARNINGS
Revision 1.2 of this manual corresponds to the MINI-CUBE model of the instrument with
the 1.x.x family of installed software.
It was drafted and carefully reviewed and this version is closely related to the instrument
model (data can be obtained from the instrument’s ID plate) and the version of the
software that controls it (data can be obtained through a procedure on the instrument
itself).
It must be read carefully before using the instrument, especially the parts relating to
safety.
ATTENTION
Do not use this manual except in its complete form.
If this manual is used in an incomplete form, DIESSE Diagnostica Senese S.p.A.
declines any responsibility for adverse results.
ATTENTION
Any instrument updating done with the customer’s authorization requires that
the user manual be updated in a corresponding manner.
DIESSE Diagnostica Senese SpA accepts no responsibility for damage caused directly or
indirectly by errors, defects, or incidents due to any use of this manual that does not
correspond with the version of the supplied instrument.
To Next Page
Loading...
