Digi PortServer TS 8 - Verifying PortServer TS 8;16 IP Address

17-8 Verifying the PortServer TS 8/16 IP Address
Verifying the PortServer TS 8/16 IP Address
Use this procedure to check the IP address on the PortServer TS 8/16.
1. Connect a terminal to a PortServer TS 8/16 port.
2. If the port is still using the default configuration, configure the terminal to use the following set-
tings (Otherwise, configure the terminal to match the port configuration):
• VT-100 emulation
• 9600 baud
• 8-bit characters
• 1 stop bit
• No parity
3. Press Enter to get a logon prompt from the PortServer TS 8/16.
4. Log on to the PortServer TS 8/16.
5. Use the set config command to verify the PortServer TS 8/16 IP address.