To Next PageTo Next Page
Need help?Do you have a question about the DigiDesign 888/24 I/O and is the answer not in the manual?
General| Audio Channels | 8 in / 8 out |
|---|---|
| Bit Depth | 24-bit |
| Simultaneous I/O | 8 in / 8 out |
| Clock I/O | Word Clock |
| Input Type | Analog |
| Output Type | Analog |
| Sample Rate | Up to 48 kHz |
| Converter Type | A/D and D/A |
| Analog I/O | 8 channels |
Explains the connectors and indicators on the 888/24 I/O.
Details the indicators and controls on the front panel of the 888/24 I/O.
Indicates the sample rate and digital format of audio inputs.
Monitors channel outputs and indicates clipping of Pro Tools output signals.
Allows adjustment of analog input levels to match external equipment.
Allows adjustment of analog output levels to match external equipment.
Balanced male XLR connectors for analog audio output connections.
Balanced female XLR connectors for analog audio input connections.
Balanced XLR connectors outputting a 24-bit digital data stream.
Balanced XLR connectors accepting a 24-bit digital data stream.
Connects the 888/24 I/O to MIX, d24, Disk I/O, or DSP Farm cards.
Unbalanced RCA jacks for S/PDIF digital audio transfers.
BNC connectors for slaving and synchronizing multiple Digidesign interfaces.
Connector for standard AC power cable, auto power-selecting.
Determining appropriate line level mode for studio compatibility.
Provides general details on analog and digital I/O, sample rates, and clock reference.
Details specifications for Analog-to-Digital conversion, including SNR and THD.
Details specifications for Digital-to-Analog conversion, including SNR and THD.
Covers power requirements, weight, and dimensions of the device.
Explains the difference between analog and digital calibration.
Discusses the concept of headroom for analog and digital devices.
Details the steps for calibrating input and output levels using Pro Tools.
Provides step-by-step instructions for calibrating the 888/24 I/O.
Guidance for calibrating systems with mixed Digidesign interfaces.
Explains the difference between analog and digital calibration.
Discusses the concept of headroom for analog and digital devices.
Details the steps for calibrating input and output levels using Calibration Tool.
Provides instructions for calibrating the 888/24 I/O with Calibration Tool.
Procedure for calibrating using an external sine wave generator.
Procedure for calibrating using a VU meter.
