To Next PageTo Next Page
Need help?Do you have a question about the DigiDesign 96 I/O and is the answer not in the manual?
General| A/D Resolution | 24-bit |
|---|---|
| D/A Resolution | 24-bit |
| Analog Inputs | 8 |
| Analog Outputs | 8 |
| Word Clock | Yes |
| Type | Audio Interface |
| Compatibility | Pro Tools HD |
| Form Factor | Rackmount |
| Digital Inputs | 8 |
| Digital Outputs | 8 |
| Connectivity | ADAT |
Details compliance with FCC, EMC, and safety standards for digital devices.
Outlines essential safety measures and warnings for operating electronic equipment.
Lists the items provided with the 96 I/O unit.
Specifies the necessary hardware and software for the 96 I/O.
Provides a brief overview of the guide's content and related documentation.
Lists the key features and capabilities of the 96 I/O digital audio interface.
Describes the features and indicators on the front of the 96 I/O unit.
Details the various input and output connectors on the rear of the 96 I/O.
Explains the function and specifications of DigiLink cables for system connectivity.
Explains Loop Sync, EXT. Clock, and SYNC MODE indicators for system synchronization.
Covers AC power input and DigiLink connections for system integration.
Details connecting older Digidesign MIX-series interfaces and DigiLink cable lengths.
Explains the meaning of the Sync Mode LEDs on the front panel.
Guides users on integrating the 96 I/O into a current Pro Tools HD system.
Provides specific instructions for connecting DigiLink and Loop Sync cables.
Outlines methods to verify the successful installation of the 96 I/O.
Details the correct sequence for powering up and shutting down the system.
Illustrates typical studio configurations with the 96 I/O.
Provides guidance on connecting audio signals and routing them via Hardware Setup.
Describes how to configure the 96 I/O through the Pro Tools Hardware Setup dialog.
Explains how to label and map Pro Tools input, output, insert, and bus paths.
Details how to assign Pro Tools channels to multiple 96 I/O outputs simultaneously.
Guides on choosing between +4 dBu and -10 dBV levels for studio compatibility.
Covers options for synchronizing the 96 I/O with other digital devices.
Describes using the EXT Clock IN port for system synchronization.
Provides instructions for safely removing an internal I/O card from the 96 I/O.
Offers a step-by-step guide for installing a new or replacement I/O card into the 96 I/O.
Offers solutions for common problems encountered during card installation or recognition.
