Repeat test with the door closed.
If ten rapid beeps are heard, the strike plate or door alignment may need adjustment to allow the lock to operate properly.
If the door does not lock when the bolt/latch is extended, the strike plate or lock position may need adjustment.
For keypad locks with deadbolt rear units:
Press = ` to extend the bolt.
Press = ` again to retract the bolt.
For keypad locks with deadlatch rear units:
Press = ` to retract the latch.
The latch will extend automatically.
For touch RFID locks with deadbolt rear units:
Touch ` to extend the bolt.
Touch ` again to retract the bolt.
For touch RFID locks with deadlatch rear units:
Touch ` to retract the latch.
The latch will extend automatically.
REAR VIEW FRONT VIEW
4
Test the lock while the door is open to ensure that the bolt or latch is operating properly.
To Next Page
Loading...
