Digilock numeris aspire - Door Mounting Holes Drill Instructions and Template

12
Door Mounting Holes Drill Instruction and Template
Drill Instructions
With the door open place the Template over the locker frame.
(a) Align the Edge of Strike Plate with the Strike Plate Marker.
(b) Center the Template to the center of the Strike Plate.
You may secure the Template with removable tape.
(a)
(b)
Strike Center
1
Close the door over the Template.
(a) Mark the door edge at the Template Center Line.
(b) Mark the Template with the edge of the door.
(b)
(a)
2
Place the Template on the front of the door.
(a) Align the drawn mark on the Template with the door edge.
(b) Center the Template with the mark on the door.
Secure the Template with removable tape.
(a)
(b)
3
Mark the center points of the door mounting holes on the front of
the door. Drill the holes according the specied dimensions.
Drill x2
5/16” 0.3125 in
(7.94 mm)
Drill 3/4”
0.75 in (19.1 mm)
4