ENGLISH
19
Check whether the Mute function is activated. Use the decoder or TV
remote control to turn it off.
Make sure the volume of your decoder or TV is high enough. Press the
volume buttons on the decoder or TV remote control to adjust.
Check that the decoder is properly connected to your TV or audio
system.
Some connections to the decoder may have been "loose".
Try disabling the CEC function on both the TV and the set-top box.
Channel loss or decoder block. Deleting channel or FAV lists
Exclude all automatic updates and resume automatic channel tuning.
The inserted USB memory is not recognized
Not all USB devices are compatible. It is recommended to use powered
HDDs that are equipped with their own power supply. Compatibility with
large capacity USB devices is not guaranteed; if problems arise, we
recommend that you run a partition or use a smaller capacity HDD.
NOTE: the manufacturer is not responsible for any damage or loss of data.
Some files are not recognized
The manufacturer cannot guarantee the playback of the files even
though the extension is supported: this depends on the Codec used, the
data bit rate and the resolution. Any codec update is the responsibility of
the main board manufacturer, it is not possible to do it via SW.
The decoder or TV turns itself off
As required by recent European energy saving regulations, this decoder
will AUTOMATICALLY TURN OFF 3 hours after the last operation, TVs
after 4 hours (autostandby).
NOTE: you can disable this function in the relevant menus.
To Next Page
