Digisol DG-GS4628E2 - Connecting Console

DG-GS4628E2 / DG-GS4628HPE-P Installation Guide
15
Fig 2- 1 Fasten the Brackets to the Switch
2. Put the bracket-mounted switch smoothly into a standard 19’’ rack. Fasten the
switch to the rack with the screws provided. Leave enough space around the switch for
good air circulation.
Fig 2- 2 Fasten the Switch to the Rack
Caution!
The brackets are used to fix the switch on the rack. They can’t serve as a
bearing. Please place a rack shelf under the switch. Do not place anything on top of
the switch. Do not block the blowholes on the switch to ensure the proper
operation of the switch.
2.3.2 Connecting Console
DG-GS4628E2/DG-GS4628HPE-P provide a RJ45 serial console port.
Fig 2- 3 Connecting Console to switch
The connection procedure is listed below: