Need help?Do you have a question about the Digisol DG-GS1528HP/C and is the answer not in the manual?
General| Type | Managed |
|---|---|
| Ports | 28 |
| Number of Ports | 28 |
| PoE Ports | 24 |
| PoE Standard | IEEE 802.3af/at |
| PoE Power Budget | 370W |
| Switching Capacity | 56Gbps |
| MAC Address Table | 8K |
| Jumbo Frame | 9KB |
| Power Supply | Internal |
| Input Voltage | 100-240V AC, 50/60 Hz |
| Certifications | CE, FCC, RoHS |
| Power Consumption | 400W (Max.) |
| Operating Temperature | 0°C to 45°C |
| Storage Temperature | -40°C to 70°C |
| Humidity | 10% to 90% non-condensing |
| Dimensions (W x D x H) | 440 x 44 x mm |
| Port Type | Gigabit Ethernet |
| Forwarding Rate | 41.67Mpps |
Describes the switch's front panel indicators, ports, and layout.
Details the rear panel components, including power input and fuse.
Instructions for unpacking the switch and verifying contents.
Guide to desktop, shelf, and rack mounting the switch.
Steps for connecting AC power and important safety precautions.
Explains web-based management and compatible web browsers.
Steps to establish a connection and log into the switch's interface.
Overview of the main components of the web interface.
Settings for enabling/disabling ports and viewing basic port information.
Displays detailed statistics for send and receive packets per port.
Enables or disables send/receive flow control for each port.
Configures broadcast storm suppression and port speed limits.
Establishes static bindings between MAC addresses and ports.
Converts dynamically learned MAC addresses to static bindings.
Configures rules to filter traffic based on MAC addresses.
Converts dynamically learned MAC addresses into static filtering rules.
Displays current VLAN configuration and port membership.
Creates and manages static VLANs by VID and name.
Assigns ports to VLANs with specific modes (access, trunk, hybrid).
Manages SNMP community strings and access permissions.
Configures destinations for receiving SNMP TRAP messages.
Creates standard Access Control Lists based on source IP addresses.
Creates extended ACLs using IP, protocol, and port criteria.
Configures ACLs based on MAC and IP address combinations.
Configures ACLs for ARP packet operations and sender control.
Applies QoS settings to ports, defining priority levels.
Configures QoS scheduling modes and queue weights.
Configures IP addresses, subnet masks, and gateways for interfaces.
Manages ARP table entries, including static and dynamic configurations.
Configures static routes for directing network traffic.
Configures RADIUS server settings for authentication and accounting.
Configures 802.1x protocol for network access control.
Configures global MSTP settings like priority and BPDU handling.
Configures MSTP settings on a per-port basis.
Enables and configures IGMP snooping for multicast traffic.
Displays information about IGMP snooping groups.
Enables or disables GMRP globally for the switch.
Configures GMRP status and timers for individual ports.
Configures EAPS ring settings, ports, and VLANs for network redundancy.
Displays information about the configured EAPS domains.
Configures RMON statistics collection for ports.
Configures RMON history collection for ports.
Configures RMON alarms based on threshold values.
Configures RMON events and their actions (log, trap).
Configures Neighbor Discovery Protocol (NDP) settings.
Configures Neighbor Topology Discovery Protocol (NTDP) settings.
Sets up and manages switch clusters.
Enables and views system log messages and levels.
Enables or disables PoE function on ports and displays status.
To Next Page
