DG-GS1528HP/C User Manual
31
8. ACL Configuration
（1）IP Standard ACL configuration page
Figure 35 is the IP standard ACL configuration page. users can through this page to build ACL standard IP-rule
base. User can select a ACL group number to create one or more rules. In a rule can match only the source IP
address field (with mask). The standard IP rules to control the source IP address packet forwarding.
Figure 35 the IP standard ACL configuration page
Users to configure the rules, the source IP address must be in with a mask, the rule can match the collection of IP
addresses. The address mask is use anti-code , if the rule were to match the IP address range 192.168.0.0 to
192.168.0.255, then the IP address can be
192.168.0.1, and its mask of 0.0.0.255.
Users to configure the rules, each rule must have a filter mode: allow or deny.
The user to create a rule in the group, the system will automatically give the rule a rule number, when to delete a
rule in the group 1 rules, other rules remain unchanged, the system will automatically give the rule a rule group
sort. If the user wants to delete the entire rule set, you can first select all, then click the delete key.
To Next Page
Loading...
