Digisol DG-GS1528HP/C - Connecting and Logging into the Switch

DG-GS1528HP/C User Manual
6
Login Web-based Management
In order to login and configure the switch via an Ethernet connection, the PC must have an IP address in the same
subnet as the switch. For example, if the switch has an IP address of 192.168.0.1, the PC should have an IP address
of 192.168.0.x (where x is a number between 2~ 254), and a subnet mask of 255.255.255.0. Open the web browser
and enter 192.168.0.1 (the factory-default IP address) in the address bar. Then press <Enter>.
Open the web browser and enter 192.168.0.1 (the factory-default IP address) in the address bar. Then press <Enter>.
Enter the IP address in the web browser
NOTE: The switch's factory default IP address is
192.168.0.1 with a subnet mask of
255.255.255.0
To log in to the switch, the IP address of your PC should be set in the same subnet as that of the switch. The IP
address is 192.168.0.x (”x” is any number from 2 to 254). Subnet Mask is 255.255.255.0.
When the following logon dialog box appears, enter the password then click OK. By default, the username is admin
and the password is admin.