DG-GS1528HP/C User Manual
52
18、Cluster configuration
(1) NDP configuration page
Figure 64 shows the NDP configuration page. You can use this page to configure NDP. The configurable
information includes: selecting the port, enabling the NDP function of the port, enabling the global NDP function, the
interval for sending NDP packets, and the aging time of the NDP packets on the receiving device.
For port selection, you can select the port as required and enable the port NDP function. For NDP to operate
normally, both global and port NDP must be enabled at the same time.
Set the aging time of the NDP packets sent by the local device to the receiving device. The valid time range is 1-
4096 seconds. The default value is 180 seconds.
Set the interval for sending NDP packets. The valid time range is 1-4096 seconds and the default is 60 seconds.
Figure 64 NDP configuration page
(2) NTDP configuration page
Figure 65 shows the NTDP configuration page. You can use this page to configure NTDP. The information that
can be set includes: selecting the port, enabling the NTDP function of the port, enabling the global NTDP function, the
range of the topology collection, the time interval of collecting the regular topology, the delay time of the first port
forwarding the packet, and the forwarding of the packet by other ports.
For port selection, you can select the port as required and enable the NTDP function on the port. For NTDP to
operate normally, both global and port NTDP must be enabled.
The range of topology collection is configured. The valid range is 1-6. In the default configuration, the maximum
number of hops from the most distant device to the topology collection device is 3.
Set the interval for collecting the topology collection. The valid range is 0-65535 minutes. The default
configuration is 1 minute.
Set the delay for forwarding packets on the first port. The valid range is 1-1000 milliseconds. The default value is 200
milliseconds.
Sets the delay for forwarding packets on the first port. The valid range is 1 to 100 milliseconds. The default value
is 20 milliseconds.
To Next Page
Loading...
