Digisol DG-FS4526 - User Manual

626 pages

Save Page as PDF

To Next Page

As our product undergoes continuous development the specifications are subject to change without prior notice

DG-FS4526

MUSTANG 4000 SWITCH SERIES

=MANAGEMENT GUIDE

V1.1

2010-09-28

Main Page

Questions and Answers

B
Barbara ChoiAug 15, 2025
What to do if I cannot connect to Digisol Switch using Secure Shell?
- L
  lewisadrianaAug 15, 2025
  If you are unable to connect to the Digisol Switch using Secure Shell (SSH), consider the following: * You may have exceeded the maximum number of concurrent Telnet/SSH sessions permitted. Please try connecting again at a later time. * Ensure the control parameters for the SSH server are properly configured on the switch, and that the SSH client software is properly configured on the management station. * Make sure you have generated a public key on the switch and exported it to the SSH client. * Verify that you have set up an account on the switch for each SSH user, including username, authentication level, and password. * Confirm that you have imported the client's public key to the switch (if public key authentication is used).
M
Melissa SmithOct 31, 2025
How to troubleshoot Digisol DG-FS4526 when I cannot connect using Telnet, web browser, or SNMP software?
- J
  jose24Oct 31, 2025
  If you're having trouble connecting to the Digisol Switch using Telnet, a web browser, or SNMP software, here are a few things to check: * Ensure the switch is powered on. * Verify the network cabling between your management station and the switch. * Confirm you have a valid network connection to the switch and that the port you're using hasn't been disabled. * Make sure the VLAN interface, through which the management station connects, is configured with a valid IP address, subnet mask, and default gateway. * Confirm the management station has an IP address in the same subnet as the switch's IP interface. * If connecting via a tagged VLAN group's IP address, ensure your management station and any intermediate switches are configured with the appropriate tag. * If you can't ...