DG-FS4526 User Manual
4-67
4
www.digisol.com
Command Usage
• Use this command in conjunction with the show running-config command to
compare the information in running memory to the information stored in
non-volatile memory.
• This command displays settings for key command modes. Each mode group
is separated by “!” symbols, and includes the configuration mode command,
and corresponding commands. This command displays the following
information:
- SNMP community strings
- Users (names and access levels)
- VLAN database (VLAN ID, name and state)
- VLAN configuration settings for each interface
- IP address configured for the switch
- Spanning tree settings
- Any configured settings for the console port and Telnet
Example
Console#show startup-config
building startup-config, please wait.....
!<stackingDB>00</stackingDB>
!<stackingMac>01_00-17-7c-0a-c9-f1_00</stackingMac>
!
phymap 00-17-7c-0a-c9-f1
!
SNTP server 0.0.0.0 0.0.0.0 0.0.0.0
!
broadcast byte-rate 1000 level 5
!
snmp-server community public ro
snmp-server community private rw
!
username admin access-level 15
username admin password 7 21232f297a57a5a743894a0e4a801fc3
username guest access-level 0
username guest password 7 084e0343a0486ff05530df6c705c8bb4
enable password level 15 7 1b3231655cebb7a1f783eddf27d254ca
!
no logging trap
!
VLAN database
VLAN 1 name DefaultVlan media ethernet state active
VLAN 4093 media ethernet state active
!
spanning-tree MST configuration
!
interface ethernet 1/1
switchport allowed vlan add 1 untagged
switchport native vlan 1
.
.
.
interface vlan 1
ip address dhcp
!
To Next Page
Loading...
Need help?
General
