Digisol DG-FS4526 - Radius-Server Timeout; Show Radius-Server

Command Line Interface
4-84
4
www.digisol.com
radius-server timeout
This command sets the interval between transmitting authentication requests to the
RADIUS server. Use the no form to restore the default.
Syntax
radius-server timeout number_of_seconds
no radius-server timeout
number_of_seconds - Number of seconds the switch waits for a reply
before resending a request. (Range: 1-65535)
Default Setting
5
Command Mode
Global Configuration
Example
show radius-server
This command displays the current settings for the RADIUS server.
Default Setting
None
Command Mode
Privileged Exec
Example
Console(config)#radius-server timeout 10
Console(config)#
Console#show radius-server
Global Settings:
Communication Key with RADIUS Server:
Auth-Port: 1812
Acct-port: 1813
Retransmit Times: 2
Request Timeout: 5
Server 1:
Server IP Address: 10.1.2.3
Communication Key with RADIUS Server: ******
Auth-Port: 1812
Acct-port: 1813
Retransmit Times: 2
Request Timeout: 5
Radius server group:
Group Name Member Index
--------------------- -------------
radius 1
Console#