Digisol DG-FS4526 - Whichboot; Boot System; Table 4-27 File Directory Information

DG-FS4526 User Manual
4-77
4
www.digisol.com
• File information is shown below:
Example
The following example shows how to display all file information:
whichboot
This command displays which files were booted when the system powered up.
Syntax
whichboot [unit]
unit - Stack unit. (Range: 1)
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows the information displayed by the whichboot command. See
the table under the dir command for a description of the file information displayed by
this command.
boot system
This command specifies the image used to start up the system.
Table 4-27 File Directory Information
Column Heading Description
file name The name of the file.
file type File types: Boot-Rom, Operation Code, and Config file.
startup Shows if this file is used when the system is started.
size The length of the file in bytes.
Console#dir 1:
file name file type startup size (byte)
----------------------------------- -------------- ------- -------------
D2218 Boot-Rom image Y 214124
V2271 Operation Code Y 1761944
Factory_Default_Config.cfg Config File Y 5197
---------------------------------------------------------------------------
Total free space: 5242880
Console#
Console#whichboot
file name file type startup size (byte)
------------------------------------- -------------- ------- -----------
Unit1:
D2218 Boot-Rom image Y 214124
V2271 Operation Code Y 1761944
Factory_Default_Config.cfg Config File Y 5197
Console#