Digisol DG-FS4526 - Aaa Authorization Exec

DG-FS4526 User Manual
4-95
4
www.digisol.com
Command Mode
Line Configuration
Example
aaa authorization exec
This command enables the authorization for Exec access. Use the no form to
disable the authorization service.
Syntax
aaa authorization exec {default | method-name} group {tacacs+
|server-group}
no aaa authorization exec {default | method-name}
• default - Specifies the default authorization method for Exec access.
• method-name - Specifies an authorization method for Exec access.
(Range: 1-255 characters)
• group - Specifies the server group to use.
- tacacs+ - Specifies all TACACS+ hosts configure with the tacacs-server
host command described on page 4-85.
- server-group - Specifies the name of a server group configured with the
aaa group server command described on 4-89. (Range: 1-255
characters)
Default Setting
Authorization is not enabled
No servers are specified
Command Mode
Global Configuration
Command Usage
• This command performs authorization to determine if a user is allowed to run
an Exec shell.
• AAA authentication must be enabled before authorization is enabled.
• If this command is issued without a specified named method, the default
method list is applied to all interfaces or lines (where this authorization type
applies), except those that have a named method explicitly defined.
Example
Console(config)#line console
Console(config-line)#accounting commands 15 default
Console(config-line)#
Console(config)#aaa authorization exec default group tacacs+
Console(config)#