EasyManuals Logo

Digisol DG-FS4526 User Manual

Digisol DG-FS4526
626 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #303 background imageLoading...
Page #303 background image
DG-FS4526 User Manual
4-17
4
www.digisol.com
Example
To specify no parity, enter this command:
speed
This command sets the terminal line’s baud rate. This command sets both the
transmit (to terminal) and receive (from terminal) speeds. Use the no form to restore
the default setting.
Syntax
speed bps
no speed
bps - Baud rate in bits per second.
(Options: 9600, 19200, 38400, 57600, 115200 bps)
Default Setting
9600
Command Mode
Line Configuration
Command Usage
Set the speed to match the baud rate of the device connected to the serial
port. Some baud rates available on devices connected to the port might not be
supported. The system indicates if the speed you selected is not supported.
Example
To specify 57600 bps, enter this command:
stopbits
This command sets the number of the stop bits transmitted per byte. Use the no
form to restore the default setting.
Syntax
stopbits {1 | 2}
• 1 - One stop bit
• 2 - Two stop bits
Default Setting
1 stop bit
Command Mode
Line Configuration
Console(config-line)#parity none
Console(config-line)#
Console(config-line)#speed 57600
Console(config-line)#

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digisol DG-FS4526 and is the answer not in the manual?

Digisol DG-FS4526 Specifications

General IconGeneral
BrandDigisol
ModelDG-FS4526
CategorySwitch
LanguageEnglish

Related product manuals