Digisol DG-FS4526 User Manual

Command Line Interface
4-150
4
www.digisol.com
Interface Commands
These commands are used to display or set communication parameters for an
Ethernet port, aggregated link, or VLAN.
interface
This command configures an interface type and enters interface configuration mode.
Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-26)
• port-channel channel-id (Range: 1-12)
• vlan vlan-id (Range: 1-4094)
Default Setting
None
Table 4-46 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters interface configuration
mode
GC 4-150
description Adds a description to an interface configuration IC 4-151
speed-duplex Configures the speed and duplex operation of a given interface
when autonegotiation is disabled
IC 4-151
negotiation Enables autonegotiation of a given interface IC 4-152
capabilities Advertises the capabilities of a given interface for use in
autonegotiation
IC 4-153
flowcontrol Enables flow control on a given interface IC 4-154
shutdown Disables an interface IC 4-155
broadcast byte-rate Configures the broadcast storm control threshold IC 4-156
switchport broadcast Enables broadcast storm control on an interface IC 4-156
clear counters Clears statistics on an interface PE 4-157
show interfaces status Displays status for the specified interface NE, PE 4-157
show interfaces
counters
Displays statistics for the specified interfaces NE, PE 4-158
show interfaces
switchport
Displays the administrative and operational status of an
interface
NE, PE 4-159

Digisol DG-FS4526 Specifications

General

Brand	Digisol
Model	DG-FS4526
Category	Switch
Language	English