DG-FS4526 User Manual
4-91
4
www.digisol.com
aaa accounting exec
This command enables the accounting of requested Exec services for network
access. Use the no form to disable the accounting service.
Syntax
aaa accounting exec {default | method-name} start-stop group {radius |
tacacs+ |server-group}
no aaa accounting exec {default | method-name}
• default - Specifies the default accounting method for service requests.
• method-name - Specifies an accounting method for service requests.
(Range: 1-255 characters)
• start-stop - Records accounting from starting point and stopping point.
• group - Specifies the server group to use.
- radius - Specifies all RADIUS hosts configure with the radius-server
host command described on page 4-81.
- tacacs+ - Specifies all TACACS+ hosts configure with the tacacs-server
host command described on page 4-85.
- server-group - Specifies the name of a server group configured with the
aaa group server command described on 4-89. (Range: 1-255
characters)
Default Setting
Accounting is not enabled
No servers are specified
Command Mode
Global Configuration
Command Usage
• This command runs accounting for Exec service requests for the local console
and Telnet connections.
• Note that the default and method-name fields are only used to describe the
accounting method(s) configured on the specified RADIUS or TACACS+
servers, and do not actually send any information to the servers about the
methods to use.
Example
Console(config)#aaa accounting exec default start-stop group tacacs+
Console(config)#
To Next Page
Loading...
