DG-FS4526 User Manual
4-319
4
www.digisol.com
upnp device
This command enables UPnP on the device. Use the no form to disable UPnP.
Syntax
[no] upnp device}
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
You must enable UPnP before you can configure time out settings for sending
of UPnP messages.
Example
In the following example, UPnP is enabled on the device.
Related Commands
upnp device ttl (4-319)
upnp device advertise duration (4-320)
upnp device ttl
This command sets the time-to-live (TTL) value for sending of UPnP messages from
the device.
Syntax
upnp device ttl {value}
• value - The number of router hops a UPnP packet can travel before it is
discarded. (Range:1-255)
Default Setting
4
Command Mode
Global Configuration
Command Usage
UPnP devices and control points must be within the local network, that is
within the TTL value for multicast messages.
Console(config)#upnp device
Console(config)#
To Next Page
Loading...
Need help?
General
