Digisol DG-FS4526 - Map Access-List Ip; Map Access-List Mac

DG-FS4526 User Manual
4-257
4
www.digisol.com
Example
The following example shows how to map IP TOS value 0 to CoS value 1 and
enable the feature on the switch.
map access-list ip
This command sets the output queue for packets matching an IP ACL rule. Use the
no form to remove the CoS queue mapping.
Syntax
[no] map access-list ip acl_name cos cos-queue
• acl_name – Name of the IP ACL. (Maximum length: 16 characters)
• cos-queue – Port CoS queue. (Range: 0-3)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
You must configure an ACL before you can map a CoS queue to the rule.
Example
map access-list mac
This command sets the output queue for packets matching a MAC ACL rule. Use the
no form to remove the CoS queue mapping.
Syntax
[no] map access-list mac acl_name cos cos-queue
• acl_name – Name of the MAC ACL. (Maximum length: 16 characters)
• cos-queue – Port CoS queue. (Range: 0-3)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Console(config)#map ip tos 0 cos 1
Console(config)#map ip tos
Console(config)#interface ethernet 1/2
Console(config-if)#map access-list ip bill cos 0
Console(config-if)#