DG-FS4526 User Manual
4-287
4
www.digisol.com
Syntax
[no] ip igmp filter
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• IGMP filtering enables you to assign a profile to a switch port that specifies
multicast groups that are permitted or denied on the port. An IGMP filter profile
can contain one or more, or a range of multicast addresses; but only one
profile can be assigned to a port. When enabled, IGMP join reports received
on the port are checked against the filter profile. If a requested multicast group
is permitted, the IGMP join report is forwarded as normal. If a requested
multicast group is denied, the IGMP join report is dropped.
• IGMP filtering and throttling only applies to dynamically learned multicast
groups, it does not apply to statically configured groups.
• The IGMP filtering feature operates in the same manner when MVR is used
to forward multicast traffic.
Example
ip igmp profile
This command creates an IGMP filter profile number and enters IGMP profile
configuration mode. Use the no form to delete a profile number.
Syntax
[no] ip igmp profile profile-number
profile-number - An IGMP filter profile number. (Range: 1-4294967295)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
A profile defines the multicast groups that a subscriber is permitted or denied
to join. The same profile can be applied to many interfaces, but only one
profile can be assigned to one interface. Each profile has only one access
mode; either permit or deny.
Console(config)#ip igmp filter
Console(config)#
To Next Page
Loading...
Need help?
General
