Digisol DG-FS4526 - Show Lldp Info Remote-Device

Command Line Interface
4-198
4
www.digisol.com
show lldp info remote-device
This command shows LLDP global and interface-specific configuration settings for
remote devices attached to an LLDP-enabled port.
Syntax
show lldp info remote-device [detail interface]
• detail - Shows detailed information.
• interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-26)
• port-channel channel-id (Range: 1-12)
Command Mode
Privileged Exec
Example
Console#show lldp info remote-device
LLDP Remote Devices Information
Interface | ChassisId PortId SysName
--------- + ----------------- ----------------- ---------------------
Eth 1/5 | 00-17-7C-0A-E2-F1 00-17-7C-0A-E2-F8
Console#show lldp info remote-device detail ethernet 1/5
LLDP Remote Devices Information Detail
---------------------------------------------------------------
Local PortName : Eth 1/5
Chassis Type : MAC Address
Chassis Id : 00-17-7C-0A-E2-F1
PortID Type : MAC Address
PortID : 00-17-7C-0A-E2-F8
SysName :
SysDescr : DG-FS4552
PortDescr : Ethernet Port on unit 1, port 7
SystemCapSupported : Bridge
SystemCapEnabled : Bridge
Remote Management Address :
192.168.1.2 (IPv4)
Remote Port VID : 1
Remote VLAN Name :
VLAN-1 : DefaultVlan
VLAN-4093 :
Remote Protocol Identity (Hex) :
88-CC
Remote MAC/PHY configuration status :
Remote port auto-neg supported : Yes
Remote port auto-neg enabled : Yes
Remote port auto-neg advertised cap (Hex) : 6C00
Remote port MAU type : 16